110,00 €
In stock
Product Details


- 2x Binaural microphones EarSight with 1.5m cable lenght

- 1 set of Silicon plugs (3 pair S, M, L) (standard earphones silicone or foam compatible)

The new version of Earsight microphones has finally arrived, the ability to record in binaural with absolute discretion.
You can now record in very high quality, with an extremely low self noise (14 dB) in total immersion.
The microphones now take the place of your ears, allowing you to hear on headphones exactly what you heard while recording.

The microphones looks like earphones and do not attract attention, so you can record in unlikely places, the microphones follow you everywhere.
Earplugs are designed specially for Earsight capsules and were 3D printed for ultra light setup.
You can't hear what you record with these mics, so I designed an event to unobstruct your hearings to avoid the sensation of boomy sound when wearing noise cancelling earplugs.
They comes with 3 size silicon plugs to fit your ears.

You can add comica Windshields to extend the capacities of the mics, they can be used like Earsight Standard in A/B configuration for ambiance recording. The windshields can't be used for in ear recordings because of their size.


  • PAIRED MINI JACK VERSION (PIP): Compatible with microphone input recorder with plug in power or PIP function. (Olympus LS series, Tascam DR100 mkIII, Sony PCM D50 or D100 and many DSLR cameras)
  • PAIRED XLR VERSION (XLR 48v): For any recorder with a 48V phantom power supply. The body of the XLR connector is equipped with components to adjust the voltage to fit the microphone power needs. It can be used also in mono as a lavalier microphone.


  • Capsule type: Electret Condenser paired stereo set
  • Directivity: Omni
  • Sensitivity: -24 dB
  • Self Noise: 14 dB-A
  • Signal-to-Noise Ratio: 80 dB
  • Frequency Range: 20Hz to 20kHz
  • Maximum SPL Input: 110 dB
  • Operating Temperature: -25°C->+70°C
  • Connector: NEUTRIK mini jack 3.5 or XLR (can be shipped in black or silver depending on availability.)
  • Cable reference: .MOGAMI lavalier microphone cable 1.5m lenght
  • Cable Diameter: Ø2 mm outside diameter
  • Earplug outside diameter: Ø12.5mm
  • Almost insensitive to RFI noise

For all the information about using Earsight mics, you can go to the following page HOW TO USE EARSIGHT MICS / FAQ

Save this product for later
Assemblé en France

The mics are available in standard version with increased sentivivity and noise floor

SOUND SAMPLES (raw files from Zoom F6, DR100mkIII, Mixpre6, Nagra LB)


EarSight nano microphones are manufactured by Immersive Soundscapes in France, in small quantities. Each model is checked before shipping. It’s also possible to offer you adapted cable lenghts to suit your needs, do not hesitate to contact me for any specific request. immersivesoundscapes@gmail.com