EACH ORDER INCLUDES:

- 2x microphone EarSight standard Version 2

- 2x détachable clips

- (windfurry not included --> Available in option)

Earsight V2 improves the design of the V1, now, you have removable clip to use the mics as lavalier or to mount them anywhere, windshields can now be installed without 3D adapter with retaining groove integrated into the microphone body.

The microphones are also lightweight but they keep the same capsule than Standard version with best signal to noise ratio and also almost insensitive to RFI noise.

This is the right balance between standard and nano versions,

TWO VERSIONS AVAILABLE:

• PAIRED MINI JACK VERSION (PIP): Compatible with microphone input recorder with plug in power or PIP function. (Olympus LS series, Tascam DR100 mkIII, Sony PCM D50 or D100 and many DSLR cameras)
• PAIRED XLR VERSION (XLR 48v): For any recorder with a 48V phantom power supply. The body of the XLR connector is equipped with components to adjust the voltage to fit the microphone power needs. It can be used also in mono as a lavalier microphone.

EARSIGHT STANDARD V2 TECHNICAL DATAS:

• Capsule type: Electret Condenser paired stereo set
• Directivity: Omni
• Sensitivity: -24 dB
• Self Noise: 14 dB-A
• Signal-to-Noise Ratio: 80 dB
• Frequency Range: 20Hz to 20kHz
• Maximum SPL Input: 110 dB
• Operating Temperature: -25°C->+70°C
• Connector: NEUTRIK metak JACK OR XLR
• Audiophile high grade audio capacitor FOR XLR VERSION
• Cable reference: .Sommer Cable - low capacitance cable
• Cable Diameter: .Ø2.6 mm outside diameter
• Microphone diameter: Ø14,5mm
• Cable capacitance : 65pF /m
• Cable conductance: 0.14 ohm/m
• Almost insensitive to RFI noise
• Cable soldered directly to the capsule, no additional connectors like mini XLR to cause noise and failure.

For all the information about using Earsight mics, you can go to the following page HOW TO USE EARSIGHT MICS / FAQ